MultiFunctional Lathe AT520

AT520 is an accurate metal lathe with mill drill and can be used for turning, drilling and milling. One of the most notable features is the spindle that can be extended in height. An automatic cross and longitudinal feed allow height performance and accuracy. Its drilling & milling head can turn 360° around, and it has longitudinal and lateral power feed. It’s an ideal DIY machine. CUTTINGMax. swing diameter over bed300mmMax. length of workpiece500mmSwing diameter over tool carrier140mmSpindle bore26mmTaper of hole in spindle morseNo.4Max. cross stroke over tool carrier200mmMax. longitudinal stroke over small tool carrier80mmMetric thread kinds on processing14Inch thread kinds on processing20Metric thread pitch on processing0.5-3mmInch thread pitch on processing11-40 1/n"Longitudinal feed grade20Cross feed grade20Longitudinal feed on spindle tool carrier0.036-1.43mmCross feed on spindle tool carrier0.003-0.134mmMax. stroke of tailstock sleeve50mmSpindle speed step6Spindle speed scope160-1600r/minElectric motor550W 220V 50HZ(110V 60HZ) DRILLING & MILLINGMax. drilling capacity20mmDistance from bench to spindle nose240-320mmDistance between spindle centre and310mmthe surface of columnSwivel-angle of the milling -drilling360°headstock around the columnMilling drilling headstock vertical stroke80mmSpindle speed step9Spindle speed scope315-2000r/minBench dimension150x425mmElectric motor370W 220V 50HZ (110V,60HZ)OTHERSNet weight230kgOverall dimension110x55x74cm STANDARD ACCESSORIESOPTIONAL ACCESSORIES13-Jaw chuck1Steady rest2Dead center2Follow rest3Aiien wrench3Face plate4Single open end wrench4Machine vice5Drill chuck5Turning tool set6change gear6Face milling cutter7ROCKER7Step block8change gear8Machine base94-Jaw chuck10Chuck backplate11Rolling center